How To Adjust Anti Sweat Valve

Connect a pipe to the one remaining port on the mixing valve using a compression fitting. Dry assemble the various copper pipes and fittings to the anti sweat valve.

Toilet Tank Anti Sweat Valve At Menards

You will need to remove the shower handle to get to the valve.

How to adjust anti sweat valve. That will fully open the cold water side and shut down the hot water. Back it up to the appropriate location over the joint and tighten with a wrench. Unscrew the other handle and then the inner parts like rings and washers.

Solder together the assembly making sure the valve is positioned vertically. After soldering the last joints it s time to test your new system. Then turn the hot water screw clockwise until it bottoms out.

Solder the valve assembly to the existing pipes. Start by turning the cold water adjustment screw counterclockwise all the way. Once you get to the valve you may need a needle nose pliers to turn it.

Https amzn to 2quwf7pif you are having a issue where you shower is not very hot but your sink has very hot water then you might need to. Install the soldered valve assembly so that it connects the hot water pipe with the cold water line leading to the toilet. Add a little teflon tape onto the ends insert the pipe and slip the compression fitting nut over the pipe.

Installing an anti sweat valve. It s time to connect a t assembly from your house s hot water line to the mixing valve. Do adjust the anti scald valve you will need a screwdriver or drill to remove all the outer components to get to the valve.

Slip vent couplings on the opposite end. Next connect the valve assembly to the water lines by soldering the connections on both the hot and cold water lines at the stop and waste valves. Amazon hex key set.

A slotted screwdriver is all you need to adjust the temperature of the water flowing through the valve.

How To Install An Anti Sweat Valve How Tos Diy